HM Digital PC-100 Panel Mount Conductivity Controller, Sensor Included
*** The PC-100 has been discontinued. It has been replaced by the PSC-150.
HM Digital PC-100 Panel Mount Conductivity Controller, PC100
Install the Panel Mount Controller to constantly monitor TDS levels of water produced by a high-output system.
Monitors and controls conductivity levels for high output commercial systems.
Large, bright L.E.D. display.
An alarm will sound if the EC level rises above the user-set level.
Installs easily in minutes.
Includes one sensor (at no extra cost).
Protective cover also available (sold separately)
Range: 0 - 999 µS/cm (micro-siemens)
Resolution: 1 µS
ATC: Yes (1 - 65 degrees Celsius)
Setting: Controlled by on-screen up/down buttons
Relay Control: The unit will open or close a circuit via dry contacts when the µS level reaches or exceeds the control setting (simple switch). It can be used to control a pump, solenoid valve or other device.
Relay Voltage: 5V
Alarm: Optional steady beep (set by user)
Display: Bright 5/8" L.E.D. display
Probe: 1/2" bushing, 3 meter (9.8 ft) shielded cable
Power supply: AC 110V / AC 220V
Dimensions: 7.2 x 7.2 x 10.2 cm (2.8 x 2.8 x 4 in.)
Monitor Weight: 476 g (1 lb .8 oz)
Total Weight: 680.4 g (1 lb 8 oz)
HM Digital EC/TDS Controllers, Sensors are included!
AUTHORIZED NATIONAL DISTRIBUTOR - ALL WATER CARE, INC
- Use coupon code "hmdigital" at check out to find out sales!
firstname.lastname@example.org - We accept credit cards via PayPal, no PayPal account is required